Tag: spacecraft

NASA will test a key deep space navigation tool this year

The Deep Space Atomic Clock (DSAC) is finally ready for testing, and NASA’s JPL has begun preparing it for launch this year after working on it for two decades. Current space vehicles and observatories already use atomic clocks for navigation — they are, after all, some of the most accurate timekeeping devices ever. However, the way they work isn’t ideal for use in vessels going beyond Low-Earth Orbit. See, the atomic clocks space agencies and companies use today need to be paired with ground-based antennas. The antenna sends signals to a spacecraft, and the vessel sends them back to Earth. Current clocks use the difference in time between sending and receiving a signal to calculate a space vehicle’s location, path and velocity. It then relays commands to the spacecraft based on those calculations. While signals travel at the speed of light, that process can still take hours — the farther the spacecraft is, the longer it has to wait for a signal. Deep Space Atomic Clock solves that issue by being onboard the spacecraft itself, which means it doesn’t need to rely on two-way tracking. It can use the signal sent from Earth to calculate for its host’s position and velocity without having to toss that signal back. That means vehicles can move and change course more quickly than current ones can, and they can focus on completing mission objectives rather than spend time readjusting antennas. In addition, DSAC will allow ground-based antennas to keep track of multiple satellites in one area — say the Martian orbit — since they don’t need to wait for vehicles to respond. DSAC will launch this year attached to General Atomic’s Orbital Test Bed spacecraft, which will blast off aboard the US Air Force Space Technology Program mission. It can head to space as a hosted payload , because it’s about the size of a four-slice toaster, much smaller than current fridge-sized atomic clocks — the agency could shrink it down even further for future missions. JPL’s ultimate goal is achieving a .03 nanosecond accuracy, but it’ll call the upcoming test a success if the prototype can maintain time accurately to within two nanoseconds. Source: NASA

Continue reading here:
NASA will test a key deep space navigation tool this year

Cassini has taken another spectacular image of its home planet

NASA As it continues to make some of its final flybys of the Saturn system, the Cassini spacecraft hasn’t entirely forgone looking back toward its home planet, Earth. And last week the spacecraft’s camera snapped a shot of Earth and the Moon (visible in a close-cropped view) from a distance of 1.4 billion km away. Some of Saturn’s rings are also visible in the new images, including the A ring (at top) with the Keeler and Encke gaps visible, and the F ring (at bottom). The Sun is behind the disk of Saturn from Cassini’s perspective, so the rings are backlit in this view. Read 1 remaining paragraphs | Comments

See original article:
Cassini has taken another spectacular image of its home planet

Boeing’s Starliner space taxi will have over 600 3D-printed parts

Boeing may have pushed the Starliner’s first trip to the ISS back to 2018, but we’re sure to get more details about the space taxi between now and then. Reuters reports the spacecraft will pack more than 600 3D-printed parts thanks to Boeing’s recent deal with Oxford Performance Materials. Printed with a plastic called PEKK, the parts are expected to perform well under the stress of spaceflight and extreme temperatures. What’s more, the material offers both weight and cost savings for parts that are typically made out of metal and other plastics. Oxford says PEKK is strong as strong as aluminum, but it weighs “significantly” less. The company says its plastic is also fire and radiation resistant in addition to being able to withstand temperatures that range from minus 300 to 300 degrees Fahrenheit. Boeing will use the PEKK material for components in a number of areas, including brackets for the propulsion system and parts for the air revitalization system. Boeing is currently constructing three Starliner capsules under a $4.2 billion contract from NASA. Elon Musk’s SpaceX is also building a space taxi capsule with its $2.6 contract with the US space agency. While Boeing expects to launch a test flight in June 2018 with a manned mission to follow in August, SpaceX also eyes a 2018 launch for its Dragon capsule. Of course, when Boeing sends a Starliner into space, its crew will be outfitted with fancy new spacesuits . Source: Reuters

Read this article:
Boeing’s Starliner space taxi will have over 600 3D-printed parts

NASA’s Cassini spacecraft sent photos of Saturn’s north pole

As Cassini winds down its 20-year mission to Saturn, the spacecraft will maneuver into a series of weeklong orbits, allowing it to get a closer look at the planet’s famous rings as it flies by. Although there are still a few days before Cassini grazes Saturn’s rings, its cameras have already sent back some initial shots of some interesting features near the planet’s northern hemisphere. The images below, for example, show the same view of a hexagonal-shaped jetstream over the planet’s north pole , as seen from about 400, 000 miles above the planet and through four different spectral filters sensitive to wavelengths of light ranging from violet to infrared. (The curved lines you see beyond the edge of the planet are the rings, of course.) Although the images Cassini sends back are relatively small — just 256 by 256 pixels square in their original format — NASA calculated that each pixel represents about 95 miles of space and each side of the jetstream is about as wide as Earth itself. Cassini will pass by the outer edges of the planet’s rings on December 11 and it should start sending back images of the rings themselves a few days later. After that, Cassini will continue circling Saturn until April 22, when it will get a closer look at the moon Titan and another orbital adjustment in the process. That final orbit will swing the spacecraft back between the planet and its rings 22 more times before it finally takes a dive into the atmosphere and loses signal around September 15, 2017.

Visit site:
NASA’s Cassini spacecraft sent photos of Saturn’s north pole

Juno has begun its tour of Jupiter after a five-year journey

Juno’s five-year journey has come to an end, and soon, it will start taking measurements and capturing images of the largest planet in our solar system. The spacecraft, which aptly carries Lego figures of the Roman god Jupiter, his wife the goddess Juno and Galileo, has entered Jupiter’s orbit after firing up its engines before midnight and performing a 35-minute maneuver. That was much harder to accomplish than it sounds — it had to be at the right speed to be captured by the gas giant’s gravity, or it would have slipped right past it. In the end, everything went well, and the spacecraft’s arrival was off only by a second . “With Juno, we will investigate the unknowns of Jupiter’s massive radiation belts to delve deep into not only the planet’s interior, but into how Jupiter was born and how our entire solar system evolved, ” NASA chief Charlie Bolden said in a statement. Besides entering Jupiter’s orbit, the probe has also successfully turned toward the sun. Now that NASA is sure the spacecraft’s solar arrays can capture enough sunlight to power it, Juno’s initial 53-and-a-half day orbit has begun. We won’t have to wait long to see and hear more about the planet either: Bolden says the probe’s science phase will officially begin in October, but it will start collecting data much earlier than that. Juno is slated to orbit Jupiter 37 times within the next 20 months to uncover its secrets. Those include understanding how it (and similar planets) formed and evolved, figuring out if it has solid core, mapping its magnetic field, measuring the amount of water, oxygen and ammonia in its atmosphere, as well as observing its majestic auroras. After it’s done, NASA plans to crash Juno into the gas giant to avoid collision with the planet’s biggest moons. Success! Engine burn complete. #Juno is now orbiting #Jupiter , poised to unlock the planet’s secrets. https://t.co/YFsOJ9YYb5 — NASA (@NASA) July 5, 2016 #Juno turned back toward the sun, has power and started its tour of #Jupiter in an initial 53.5-day orbit pic.twitter.com/iwRSSOwPwX — NASA (@NASA) July 5, 2016 #Juno is in Jupiter’s orbit! See how the team is feeling and find out what’s next at 1am ET: https://t.co/KX5g7yYnYG pic.twitter.com/TlcOjCVE4E — NASA (@NASA) July 5, 2016 Fun trivia: Google is celebrating Juno’s successful arrival with a cute animated Doodle. Source: NASA (Twitter)

Read the original:
Juno has begun its tour of Jupiter after a five-year journey

Virgin Galactic says it’s on track to begin tours of space in 2014

Virgin Galactic’s SpaceShipTwo underwent its second successful rocket-powered test flight yesterday, demonstrating its “wing-feathering” capabilities for the first time. In a video announcement released soon thereafter, Virgin CEO Richard Branson stated the company is “on track for a 2014 start of commercial service.” Rich space-enthusiasts, rejoice! Read more…        

View post:
Virgin Galactic says it’s on track to begin tours of space in 2014